What is HP Printer Error 59.F0 ?
This error is primarily caused by a transfer alienation failure within which the ITB is stuck and unable to rotate, the SR9 sensor (the primary transfer roller disengagement sensor) has gone bad or the fuser drive assembly has unsuccessful.
Getting error like HP Printer Error 59.F0, then Contact HP Tech Support Team:
|HP Printer Support phone number||+1-844-813-3268|
For a HP Printer Error 59.F0 error, typically we suggest you try resetting the transfer belt assembly sometimes, also try to reset the toner and therefore the fuser assembly. If you’ve got spares of any of those components you can install them to help eliminate culprits. The problem will be a failing Transfer Belt Assembly.
There is also a Fuser Drive Assembly mechanism which may fail, that turns a flag on your transfer belt assembly.
Typically if the Drive Assembly is broken that gear can “skip” or maybe not spin at all. If you’re hearing a “clicking” noise as this take a look at runs, it’s possible that this Fuser Drive Assembly is broken and desires a replacement.
Follow the directions below to Perform an “ITB Contact Alienation” test:
- Open the correct side door and take away the transfer belt assembly.
- Open the toner access door, and take away the Cyan cartridge.
- Refer to the image that is below, insert a flat blade screwdriver into the little slot on the front, keep that screwdriver inserted whereas you run the take a look at. The screwdriver is pressing on a lever within the opening which simulates the toner access door is closed.
- Press the Menu button and use the Down Arrow to find diagnostics. Press OK.
- Press the Down arrow till you find element test, press OK.
- Press the Down arrow till you highlight ITB CONTACT / ALIENATION, and press OK. Once you press OK, you ought to start looking the small white gear pointed to . Throughout this take a look at that small gear is meant to spin, and our guess is, the gear is not spinning or if it will spin, it skips. If you hear a clicking noise throughout the operation, that’s also a sign the Fuser Drive Assembly is broken.
Now, if you’ve got determined the Fuser Drive Assembly is that the problem, we tend to do sell this part. However, keep in mind it’s a huge job to install this part, typically a 2-3 hour job. In several cases, customers would prefer to possess a technician install it as an alternative replace the printer. provide us a decision with any queries. Also, there are two versions of the fuser drive assembly, if you’ve got a duplexing machine (CP3525DN, CP3525X, CM3530, CM3530FS) you wish the duplexing fuser drive assembly if you’ve got a simplex machine (CP3525N) you may need the simplex drive assembly
Simple steps to resolve HP Printer Error 59.F0
- Check the ITB alienation sensor (m) by acting either the manual sensor test or the paper-path sensors test within the Troubleshooting menu.
- Reconnect the connectors of the ITB home-position sensor (J2010), the cartridge driver PCA (J406, J407), and therefore the DC controller PCA (J142).
- Perform the ITB contact/alienation element test within the Troubleshooting menu.
- Reconnect the connectors of the primary-transfer-roller disengagement motor (J1709) and therefore the DC controller PCA (J110).
- Replace the primary-transfer-roller disengagement motor. See Primary transfer-roller disengagement motor on page 292.
Comment below if you have any queries regarding How to resolve HP Printer Error 59.F0